Pom-Pom and Tassel Maker Set

Pom-pom makers and tassel makers in a set of sizes: C-shaped ring pairs for pom-poms and slotted cards for tassels, each with its size on it.

Customise it in your browser, then download a print-ready STL, or a multi-colour 3MF. No CAD skills needed.

About the Pom-Pom and Tassel Maker Set

A set of pom-pom makers and tassel makers in the sizes you choose. Each pom-pom maker is a pair of C-shaped rings: wind yarn round them, cut between the rings, tie and slide off. Each tassel maker is a card with a slot to tie through at the top and cut through at the bottom.

Pom-Pom and Tassel Maker Set: a customisable 3D print, shown at its starting settings

What you can change

Type your own pom-pom sizes and tassel lengths.
Pick its colour.

What you download

An STL or 3MF for any slicer.

Printing it

Prints flat with no supports. Each pom-pom size is a pair of rings: put them together lip to lip. The finished pom-pom comes out about the size on the ring, a little smaller once it’s trimmed.

Ideas for using it

Bobbles for knitted hats.
Garlands and bunting with children.
Tassels for cushions and bookmarks.

Questions

What size comes out?

A pom-pom comes out about the size on the ring, a little smaller once it’s trimmed round.

How much yarn?

The more you wind on, the fuller it is: wind until the middle hole is nearly closed.

Which printers and slicers does it work with?

Any FDM printer. The STL opens in every slicer; the 3MF keeps the colours as separate parts in Bambu Studio, Orca Slicer, PrusaSlicer and Cura. Pick your printer in the designer to check it fits the plate.

Can I sell what I make?

On Pro and Ultimate you can sell the prints you make, for example on Etsy or at craft fairs, for as long as your membership is active: if it ends, stop selling them. On Free and Maker, print it for yourself or give it as a gift. The STL and 3MF files themselves are never for sharing or selling.