Filamora Studios › Home & garden

Funny Signs

A Caution, Notice or Danger sign with a joke on it, for a bedroom door, the kitchen or a shed. Prints flat with no AMS, or on paper to frame.

Customise it in your browser, then download a print-ready STL, or a multi-colour 3MF. No CAD skills needed.

About the Funny Signs

A funny safety sign: Caution, Notice or Danger in a band across the top and a joke underneath, for a teenager’s bedroom, the kitchen, a shed or a desk. Pick a preset or write your own, and make any line big by starting it with !.

Funny Signs by Filamora Studios: a customisable 3D print, shown in use at its starting settings

What you can change

  • Type your own header and the words.
  • Style: caution, notice and danger.
  • Font: 35 to choose from, from script to stencil.
  • Adjust width and height.
  • Turn on or off: holes to hang it and my own colours.

What you download

An STL for any slicer, and a 3MF with each colour as its own part, ready for an AMS or a filament change; or a PDF to print on paper or card and cut out.

Printing it

Prints flat with no supports, and no AMS: change filament where the band and words start, and back to the board colour where the header starts. Hang it on two small nails or screws, or stick it up with sticky pads. On paper: print the PDF at 100% (actual size) on card, and cut along the fine grey lines; then trim round it, or frame it.

Questions

Does it need an AMS?

No: the board, then the band, frame and words, then the header, each at its own height.

Can I print it on paper?

Yes: choose paper and print it to frame or trim round.

Do I need a multi-colour printer?

No. Print it in one colour, or in colours with a filament change: the Colours line under the 3D view says at which height to change. With an AMS or another multi-colour printer, the 3MF prints it in one go.

Which printers and slicers does it work with?

Any FDM printer. The STL opens in every slicer; the 3MF keeps the colours as separate parts in Bambu Studio, Orca Slicer, PrusaSlicer and Cura. Pick your printer in the designer to check it fits the plate.

My 3MF opens all grey in Bambu Studio. What do I do?

Download the 3MF again: files made before 3 November 2026 open in one colour in Bambu Studio 2.9 and later. A new one brings its colours, and Bambu Studio asks you to match each to one of your filaments. With an older file, File → Import → Import 3D Models (Ctrl+I) often keeps the colours, or select each part and press 1, 2, 3… to put it on that filament.

Can I sell what I make?

On Pro and Ultimate you can sell the prints you make, for example on Etsy or at craft fairs, for as long as your membership is active: if it ends, stop selling them. On Free and Maker, print it for yourself or give it as a gift. The STL and 3MF files themselves are never for sharing or selling.

More Home & garden