Filamora Studios › Home & garden

Book and Coffee Stand

A rounded tray with a coaster for your mug and an A-frame tent to rest an open book on, spine up, so it keeps your page. The coaster can be inlaid in a second colour.

Customise it in your browser, then download a print-ready STL, or a multi-colour 3MF. No CAD skills needed.

About the Book and Coffee Stand

A tray for the bedside or sofa: a recessed coaster for your mug at one end, and an A-frame tent at the other to rest an open book on, spine up, so it keeps your page without cracking the spine. The coaster can be inlaid in a second colour.

Book and Coffee Stand by Filamora Studios: a customisable 3D print, shown in use at its starting settings

What you can change

  • Pick the main and coaster colours.
  • Adjust length, width, rim height and mug base, and more.
  • Turn on or off: coaster in a second colour.

What you download

An STL for any slicer, and a 3MF with each colour as its own part, ready for an AMS or a filament change.

Printing it

Prints flat as it sits, with no supports: the book tent is hollow and its sides are steep enough to print on their own. For the two-colour coaster, the 3MF has the second colour set already (it’s only the top few layers, so few colour changes). Lay your book open on the tent, spine up, to keep your page.

Ideas for using it

  • Reading in bed with a cup of tea.
  • A cookbook kept open in the kitchen.
  • A gift for a book lover.

On our blog: Ten desk upgrades to print

Questions

Will it fit my mug?

Measure the widest part of your mug’s base; the coaster is made a little bigger.

Will it fit a big book?

Make the tent taller and wider for hardbacks; the pages hang over the sides.

Do I need a multi-colour printer?

No. Print it in one colour, or in colours with a filament change: the Colours line under the 3D view says at which height to change. With an AMS or another multi-colour printer, the 3MF prints it in one go.

Which printers and slicers does it work with?

Any FDM printer. The STL opens in every slicer; the 3MF keeps the colours as separate parts in Bambu Studio, Orca Slicer, PrusaSlicer and Cura. Pick your printer in the designer to check it fits the plate.

My 3MF opens all grey in Bambu Studio. What do I do?

Download the 3MF again: files made before 3 November 2026 open in one colour in Bambu Studio 2.9 and later. A new one brings its colours, and Bambu Studio asks you to match each to one of your filaments. With an older file, File → Import → Import 3D Models (Ctrl+I) often keeps the colours, or select each part and press 1, 2, 3… to put it on that filament.

Can I sell what I make?

On Pro and Ultimate you can sell the prints you make, for example on Etsy or at craft fairs, for as long as your membership is active: if it ends, stop selling them. On Free and Maker, print it for yourself or give it as a gift. The STL and 3MF files themselves are never for sharing or selling.

More Home & garden