Filamora Studios › Desk & gadgets

Tube Stand

A stand of bent round tubes for a phone, tablet, laptop or book: a lip at the front, a back rest leaning back (straight or in a wave), the slot sized to your device. Or a zig-zag laptop stand, or a zig-zag rack with a slot for each laptop or tablet. One to nine tubes side by side.

Customise it in your browser, then download a print-ready STL, or a multi-colour 3MF. No CAD skills needed.

About the Tube Stand

A stand made of round tubes bent into shape, side by side: one runs along the table and turns up into a lip at the front, another rises behind the slot and leans back, straight or in a wave. Or a zig-zag laptop stand, the laptop standing between two zig-zag panels; or a rack of zig-zag slots for a laptop, tablet or book in each. Set the slot to your device with its case on, the heights and how many tubes.

Tube Stand by Filamora Studios: a customisable 3D print, shown in use at its starting settings

What you can change

  • Shape: A stand, A zig-zag laptop stand and A rack.
  • Back rest: straight and A wave.
  • Print it: on its side and standing up.
  • Pick its colour.
  • Adjust device thickness, with its case, lean back, back rest height and front lip height, and more.
  • Turn on or off: pockets for stick-on rubber feet.

What you download

An STL or 3MF for any slicer.

Printing it

Prints lying on its side with no supports: the tubes stack on each other, and the bottom one has a small flat to grip the bed. Or print it standing up, with supports, for rounder faces. A rack too long for your bed on its side may fit standing up. The zig-zag laptop stand prints standing up with no supports: the gaps under its arches are narrow enough to bridge. Measure your device with its case for the slot. For a soft, matt look like the photos, turn on fuzzy skin in your slicer.

Ideas for using it

  • Your phone on the desk for calls.
  • A tablet in the kitchen for recipes.
  • A closed laptop standing upright beside the monitor, or two or three in a rack.

On our blog: Ten desk upgrades to print

Questions

How do I size the slot?

Measure your device with its case and type that in: the slot is exactly that wide between the tubes.

How do I get the soft, matt look?

Turn on fuzzy skin in your slicer. It suits the round tubes and hides the layer lines.

Which printers and slicers does it work with?

Any FDM printer. The STL opens in every slicer; the 3MF keeps the colours as separate parts in Bambu Studio, Orca Slicer, PrusaSlicer and Cura. Pick your printer in the designer to check it fits the plate.

Can I sell what I make?

On Pro and Ultimate you can sell the prints you make, for example on Etsy or at craft fairs, for as long as your membership is active: if it ends, stop selling them. On Free and Maker, print it for yourself or give it as a gift. The STL and 3MF files themselves are never for sharing or selling.

More Desk & gadgets