Filamora Studios › Desk & gadgets

Desk Can Holder

A cup for a can, bottle or mug that clamps to the edge of your desk: a C-clamp with a thumbscrew, and a cup that slides onto it. Sized to your drink and your desk.

Customise it in your browser, then download a print-ready STL, or a multi-colour 3MF. No CAD skills needed.

About the Desk Can Holder

A cup that clamps to the edge of your desk, so a can or bottle stays off the desk and can’t be knocked over your keyboard. A C-clamp grips the desk with a thumbscrew from underneath, and the cup slides onto it on a dovetail. Size the cup to your drink and the clamp to your desk.

Desk Can Holder by Filamora Studios: a customisable 3D print, shown in use at its starting settings

What you can change

  • Cut-out down the front: none, window, to see the label and slot for a mug handle.
  • Pick its colour.
  • Adjust inside of the cup, cup height, thickest desk it fits and how far it grips onto the desk.

What you download

An STL or 3MF for any slicer.

Printing it

Three parts, no supports: the clamp lying on its side, the cup upright, and the thumbscrew standing on its knob. Push the clamp over the desk’s edge, screw the thumbscrew up through the bottom jaw until it grips, then slide the cup’s tongue down into the channel. PETG is tougher for a clamp; 4 walls make the threads strong.

Ideas for using it

  • A can of fizz by your gaming desk.
  • A water bottle beside the workbench.
  • A mug by the sofa table.

On our blog: Ten desk upgrades to print

Questions

Will it fit my desk?

Set the thickest desk it should fit; the thumbscrew tightens down to about 12 mm.

How do the parts go together?

Clamp it to the desk, tighten the thumbscrew, and slide the cup’s tongue down into the channel on the clamp.

Will a mug fit?

Yes: pick the Mug start (or set the cut-out to the handle slot) for a slot open at the top, facing away from the desk, that the handle drops down into. Make the slot a little wider than your mug’s handle.

Which printers and slicers does it work with?

Any FDM printer. The STL opens in every slicer; the 3MF keeps the colours as separate parts in Bambu Studio, Orca Slicer, PrusaSlicer and Cura. Pick your printer in the designer to check it fits the plate.

Can I sell what I make?

On Pro and Ultimate you can sell the prints you make, for example on Etsy or at craft fairs, for as long as your membership is active: if it ends, stop selling them. On Free and Maker, print it for yourself or give it as a gift. The STL and 3MF files themselves are never for sharing or selling.

More Desk & gadgets