Toploader & Sleeve Vertical Desk Caddy

About the Toploader & Sleeve Vertical Desk Caddy

A tower of shelves for a trading card collector’s supplies, each lying flat in its own pile: penny sleeves, toploaders, semi-rigids or sleeved cards, up to four shelves, each as tall as the pile you keep. A lip with a thumb gap along each shelf, and a bottom shelf that sticks out to slide them off. It takes little room on a desk and prints on its back with no supports.

What you can change

• Top shelf: penny sleeves, toploaders, semi-rigids and sleeved cards.
• Second shelf: nothing, penny sleeves, toploaders, semi-rigids and sleeved cards.
• Third shelf: nothing, penny sleeves, toploaders, semi-rigids and sleeved cards.
• Fourth shelf: nothing, penny sleeves, toploaders, semi-rigids and sleeved cards.
• Texture: none, lines, tiles, bricks, diamonds and honeycomb.
• Pick its colour.
• Adjust how many penny sleeves, how many toploaders, how many semi-rigids and room above each pile, for fingers, and more.
• Turn on or off: A lip along each shelf’s front, with a thumb gap and bottom shelf sticks out, to slide them off.

What you download

An STL or 3MF for any slicer.

Questions

How many does it hold?

As many as you set: each shelf is as tall as its pile and the room above it for your fingers. Pick what goes on each shelf, top to bottom, and how many.

Does it need supports?

No. It prints lying on its back, so the shelves are walls; stand it up when it’s done.

My toploaders are a different size

Measure one and type its width, length and thickness under Sizes. Each shelf is as wide as what’s on it, and as deep as the longest thing on any (or, without lips, a little shorter than its own, so they stick out to take hold of).

Which printers and slicers does it work with?

Any FDM printer. The STL opens in every slicer; the 3MF keeps the colours as separate parts in Bambu Studio, Orca Slicer, PrusaSlicer and Cura. Pick your printer in the designer to check it fits the plate.

Can I sell what I make?

On Pro and Ultimate you can sell the prints you make, for example on Etsy or at craft fairs, for as long as your membership is active: if it ends, stop selling them. On Free and Maker, print it for yourself or give it as a gift. The STL and 3MF files themselves are never for sharing or selling.